And I'm getting faster. I've spent about 8 hours so far, and I figure, after 2 more hours, I'll have my:
all hooked up and ready to start churning out sawdust. I' reusing components from my old shop, which means taking metal foil tape off of elbows to reshape them for my current needs, and that's slowing me down quite a bit.
This will be stage one. Stage two, which I'll start in a few months, I'll expand it to add a floor sweep, my radial arm saw, my chop saw, disk sanders and a drop for my mobile bandsaw & shaper.
Todd
- tablesaw
- router table
- jointer/planer
- horizontal edge sander
- wide belt sander
all hooked up and ready to start churning out sawdust. I' reusing components from my old shop, which means taking metal foil tape off of elbows to reshape them for my current needs, and that's slowing me down quite a bit.
This will be stage one. Stage two, which I'll start in a few months, I'll expand it to add a floor sweep, my radial arm saw, my chop saw, disk sanders and a drop for my mobile bandsaw & shaper.
Todd
My 3rd dust collector ductwork system in ~10 hours
0 commentaires:
Enregistrer un commentaire