Hello Everyone,
I recently bought a used Epilog Summit Laser. It seems to be working well.
It came with a factory manual, but I had to download the driver from Epilog's website.
The 32 bit driver seems quite basic. Maybe I didn't install it correctly or something.
It does give you a selection for setting raster and vector speed and power. But not a nice menu with slider buttons, etc.
The manual refers to a "stamp" driver for creating rubber stamps, with special settings, but this is not on Epilogs website.
Does anyone out there have the more complete set of drivers/software for this Summit?
Also, on another note, when vector cutting circles in 1/8" wood, the edges are not smooth, but square cuts are. Anything to make the circles smoother?
Thanks,
Jeff
I recently bought a used Epilog Summit Laser. It seems to be working well.
It came with a factory manual, but I had to download the driver from Epilog's website.
The 32 bit driver seems quite basic. Maybe I didn't install it correctly or something.
It does give you a selection for setting raster and vector speed and power. But not a nice menu with slider buttons, etc.
The manual refers to a "stamp" driver for creating rubber stamps, with special settings, but this is not on Epilogs website.
Does anyone out there have the more complete set of drivers/software for this Summit?
Also, on another note, when vector cutting circles in 1/8" wood, the edges are not smooth, but square cuts are. Anything to make the circles smoother?
Thanks,
Jeff
Epilog Summit Laser- driver and software help needed...
0 commentaires:
Enregistrer un commentaire