Not sure if I like it - 3mm was ok but I have just cuit some 6mm and although the machine ate it up no problems it did produce a load of smoke and there were a couple of flare ups which had me a bit twitchy but the went out straight away.
I was using the following settings: Power=90, Speed=0.5, PPI/Hz=1000, Air Assist=On
As I said, it cut it no worries (didnt go all the way through with Power=80) but do these settings seem about right to the more (not hard) experienced out there?
P.S. not sure I could stand the stress cutting anything thicker :eek:
I was using the following settings: Power=90, Speed=0.5, PPI/Hz=1000, Air Assist=On
As I said, it cut it no worries (didnt go all the way through with Power=80) but do these settings seem about right to the more (not hard) experienced out there?
P.S. not sure I could stand the stress cutting anything thicker :eek:
cutting 6mm MDF
0 commentaires:
Enregistrer un commentaire