I have a new to me delta unisaw, came with a bies fence, yesterday I was using it for the first time and noticed the fence has a wave to it, I held a straight edge to it and it looks like 1/16 or so dip in the one spot. how can I fix this??
2015-02-26 17.43.07.jpg
also I bought a new Oshlun SBW-100024 10-Inch 24 Tooth ATB Ripping Saw Blade. and when ripping walnut I get saw marks (not horrible but you can see them), I have not had a rip blade before always used a combination, is this just the blade or is it a saw issue?
I check the blade run out and whether everything is parrallel. it all seemed ok. could probably used tuned up at some point, I did adjust the fence to be parallel to miter slot as well as I could.
2015-02-26 17.43.07.jpg
also I bought a new Oshlun SBW-100024 10-Inch 24 Tooth ATB Ripping Saw Blade. and when ripping walnut I get saw marks (not horrible but you can see them), I have not had a rip blade before always used a combination, is this just the blade or is it a saw issue?
I check the blade run out and whether everything is parrallel. it all seemed ok. could probably used tuned up at some point, I did adjust the fence to be parallel to miter slot as well as I could.
beismeyer fence is not flat? saw marks as I am ripping?
0 commentaires:
Enregistrer un commentaire